DIY: Producer / DJ furniture made of wood panels, by Jonathan

Related projects
TOSIZE Furniture
New!
Check out our new shelf cabinets 3D configurator
Logo TOSIZE.se
Start designing right away

Create this project yourself with sheet material cut to size by TOSIZE.se!

Average

1 minuut

Description

Good furniture is important to be able to work comfortably with my producer/DJ equipment. The furniture is made without legs, so it is virtually floating.

DIY floating desk

I started with a construction drawing, in which I took a good look at where I wanted something and whether that also fit. When the wood arrived, I varnished it three times (transparent). It was spruce wood. I drilled round holes in the wood to make it easy for wires to pass through.

I then attached the beam and the brackets to the wall (first sawing off a small piece). Then it was the magazine's turn. A slat attached to the side, so that the top is firmly anchored. Then the brackets were attached again and the plank on top.

The wooden pine beams and slats were later sawn to size to the following dimensions:


    li>Spruce Planed Round Corner 44x70 mm: 165.0 cm
  • Spruce Planed Straight Corner 18x45 mm: 159.4 cm


Because I used brackets instead of a wooden stand, I had a little too much wood.

Custom DJ furniture

165.0 cm x 55.0 cm

Tip! Also check out our handy DIY tips!

What now?

This is a project for inspiration. Because our assortment has changed, (some of) the products are no longer available.


View all sheet materials